You and Al Capone.
Who told y-!?!?! I mean, nuh-uh! 
2 Likes
My work office is like yours and my home-set up has the desk in the middle of the room. I don’t do bending or contorting either AND it allows me to use every last square inch of deskspace.
Update, 25 days later. I don’t think Audiophile time is the same as regular time. It feels like I took the previous shot a lifetime ago. (RNHP hiding under Soncoz DAC)
5 Likes
Good stuff there @elementze Twisting signal cables, cheap and effective way to reduce noise. The other thing is separating signal and power wires, leaving as much space as possible between the two and if you must cross a signal and power wire, make sure they’re crossing at 90 degree angle.
2 Likes
Replaced the cheap USB cable with a short 1’ Pangea cable. Also purchased a cheap red power cable to go along with the blue one I’ve had laying around for a few years.
The USB cable is meant as an upgrade obviously, but the power cables are just for looks and better cable management since the back of the stack is right out in the open for everyone to see.
10 Likes
Those power cables are beautiful.
2 Likes
Left and Right channel power cables. 
BTW, I like the efficient curl on the XLR cables. Perfect way to get that cable from point A to point B.
4 Likes
I did not realize WBC, world’s best cables, had a power cable too. Have had ood success with their RCA’s and XLR cables past 2 years…No complaints at all.
1 Like
As far as I know, they don’t make power cables. That velcro strap came with the XLR’s. I’m just using it to hold the Raspberry power cord to it, tucked in behind it out of sight.
1 Like
Just see it as an opportunity for improvement!
it’ll get improved when I move. The issues are many fold. some cables are feet to long, others way to short. The wall warts make this difficult. When I move I think I may mount the power bar to the under side of the table and mount some hooks on the opposite side to hold the cable loops.
Got that beat by a country mile.
what a mess!
Someone’s been throwing some serious dollars at their cabling. That BNC cable is sexy schmexy perfect length! Custom? What are you using to power the Singer DDC?
Respek boss man!
Appreciate it man! Yeah, BNC is just a short version of the standard Cardas Parsec + BNC to RCA adapter. Singxer, I’m just using the stock PSU since the unit itself runs off super capacitors. The PSU just powers the caps so an LPS won’t make a huge improvement.
3 Likes